Pol-Ease 2350 Sealer & Release Agent (26lb)


Pol-Ease 2350 Sealer & Release Agent (26lb) by Polytek at Accelerated Artist. MPN: Pol-Ease 2350. Hurry! Limited time offer. Offer valid only while supplies last. Apply to porous models when making polyurethane and silicone rubber molds. Multiple coats may be required depending on the porosity of the model. Allow the solvent to fully evaporate before applying liquid rubber. For Casting: Can be applied to silicone rubber molds when casting liquid silicone. Allow the solvent to fully evaporate before casting. Use of a soft brush to evenly distribute this product or dispense with a Sure Shot Atomizer. NOTES: Shake or stir before use.Semi-permanent Sealer & R


Pol-Ease 2350 Sealer & Release Agent (26lb) by Polytek
4.2 out of 5 stars with 51 reviews
Condition: New
Availability: In Stock
$91.99


Quantity:  

 


Product Description & Reviews

Apply to porous models when making polyurethane and silicone rubber molds. Multiple coats may be required depending on the porosity of the model. Allow the solvent to fully evaporate before applying liquid rubber. For Casting: Can be applied to silicone rubber molds when casting liquid silicone. Allow the solvent to fully evaporate before casting. Use of a soft brush to evenly distribute this product or dispense with a Sure Shot Atomizer. NOTES: Shake or stir before use.

Features & Highlights

  • Semi-permanent Sealer & Release Agent
  • White petrolatum dissolved in mineral spirits
  • For Mold Making
  • For Casting

Additional Information

Brand:
Polytek
Manufacturer:
Polytek
Category:
Release Agents
MPN:
Pol-Ease 2350
UPC:
686603383766
Part Number:
Pol-Ease 2350
Publisher:
Polytek
Binding:
Office Product

 


Have questions about this item (Pol-Ease 2350), or would like to inquire about a custom or bulk order?


If you have any questions about this product by Polytek, contact us by completing and submitting the form below. If you are looking for a specif part number, please include it with your message.

First Name:
Last Name:
Email Address:
Your Message:

Related Best Sellers


mpn: Pol-Ease 2500, ean: 0686603383742,
Molds will not last as long as they would if Pol-Ease 2300 Release Agent was used. The main reason for using Pol-Ease 2500 in a polyurethane mold would be to cast a part that can be cleaned more easily than a part covered with Pol-Ease 2300. This is ...

mpn: Pol-Ease 2601, ean: 0686603383872,
NOTES: As with other releases containing silicone, castings may need to be washed before applying finishes. Because this release agent is water-based, it does not affect the dimensions of cured rubber molds as much as releases that contain solvents. ...

mpn: Pol-Ease 2650, ean: 0686603383896,
NOTE: Shake or stir before use.Silicone-free release agent. For casting concrete or plaster into polyurethane rubber molds. Brush or spray as light of a coating as possible into the mold. No drying time is needed- castings can be done immediately.

mpn: PolyCoat, ean: 0686603383858,
PolyCoat can be used in both mold making and casting applications.Low-viscostity. Semi-permanent. Sealer. Release Agent. Leaves behind a thin coating of silicone.